![]() This will give the screws a place to grab in their new location. You might need to whittle a little filler pin and glue it in place. Moving the plate slightly will give you a problem with the screw holes. ![]() With a sharp chisel you can trim out the wood up to the line. With a sharp pencil draw an outline of where it needs to be on the jamb. Use the screwdriver and remove the strike plate. Moving the strike plate any significant amount will involve removing it and chiseling out the mortise. Use a block of wood and a hammer to tap the strike plate in the right direction. Use a screwdriver to loosen the screws slightly. Move it away from the center if the strike will not seat when the door is closed.įor minor adjustments, you may be able to loosen the plate and tap it in the direction you need. To snug the door up you would move the strike plate toward the center of the door jamb. Move it away from the center if the strike will not seat when the door is closed.įor an exterior door you want the door to snug up against the weatherstripping. The strike plate may need to move in or out slightly to allow the strike to seat correctly. Two, the door is not tight against the weatherstripping. If the door is adjusted properly, there would be two reasons to move the plate. See ' Adjusting Interior Doors' and ' How To Adjust Exterior Doors' for more information and instructions on how to align the door. Before you attempt to adjust the strike plate, make sure the door does not need to be adjusted. Moving the strike plate should not be needed most of the time. Tightening the hinges or adding a support screw may be all that is need to get the door working correctly. When that happens the door strike will not align with the strike plate. Over time, the weight of the door will cause it to sag. Assuming the carpenter installed the door correctly originally, what would cause it not to work now? Age and gravity are the two main things that will affect a door. Many problems with doors and hardware can be solved with some adjustment to the door. If this is not your problem, see ' Door Repair' for all of the Door Repair topics. If they don't line up the lock won't work properly. The strike plate receives the door latch and/or deadbolt for your door lock.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |